- 38 -
B. Two-color printing
Two-color printing is performed using two-color thermal paper if the two-color print
command is executed and if two-color paper is selected by the customized value setting
with Function 5 of the GS ( E command.
fn
Format Function
1
GS ( E pL pH fn d1 d2
Changes into the user setting mode
2
GS ( E pL pH fn d1 d2 d3
Ends the user setting mode
session. (Performs a soft reset.)
3
GS ( E pL pH fn [a1 b18...b11]… [ak
bk8...bk1]
Sets value(s) for the memory
switch.
4
GS ( E pL pH fn a
Transmits the settings of the
memory switch to the host.
5
GS ( E pL pH fn [a1 n1L n1H]… [ak
nkL nkH]
Sets the customized value(s).
6
GS ( E pL pH fn a
Transmits the customized value
settings.
7
GS ( E pL pH fn a d1 d2
Copies the user-defined page.
8
GS ( E pL pH fn y c1 c2 [x d1… d(y
Xx)]k
Defines data in column format for
the character code page in the
active area.
9
GS ( E pL pH fn x c1 c2 [y d1… d(y
Xx)]k
Defines data in raster format for the
character code page in the active
area.
10
GS ( E pL pH fn c1 c2
Deletes the data in the character
code page in the active area.
11
-
-
12
GS ( E pL pH fn a
Transmits the communication
conditions for the serial interface.
•
pL, pH
specify (
pL + pH
× 256) as the number of bytes after
pH
(
fn
and
[parameter]
).
• The user setting mode is a special mode to change the values in the NV user memory
with this command.
• In Function 2, the printer performs software reset. Therefore, the printer clears the
receive and print buffers, and resets all settings (user-defined characters, macros, and
the character style) to the mode in effect at power on.
To Next Page
Loading...
