Samson 373 Series Operating Instructions

EB 8389 EN 23
Monitoring
Table2: Reset functions
All adjusted parameters and recorded measured values of the specied diagnostic test are
reset, if not listed separately.
Function
Resetting
single status
messages
Code
36 - Diag
Code
36 - Std
Operating hours counter
Device switched on since (last) initialization NO YES YES
Device in operation since initialization NO YES YES
Status classication NO NO YES
Logging YES NO YES
Statistical information
Open/Close
1)
Parameters YES NO YES
Measured values YES YES YES
Data logger
2), 3)
NO YES YES
Valve position x histogram YES YES YES
Short-term monitoring YES YES YES
Set point deviation e histogram YES YES YES
Short-term monitoring YES YES YES
Cycle counter histogram YES YES YES
Short-term monitoring YES YES YES
Drive signal diagram steady-state YES YES YES
Short-term monitoring YES YES YES
Drive signal diagram hysteresis (d5) YES YES YES
Short-term monitoring YES YES YES
Trend of travel end
position
Reference value YES YES YES
Parameters, measured
values
YES YES
YES
Tests
Drive signal dia-
gram steady-state
(d1)
Reference values NO NO YES
Measured values YES YES
YES

Samson 373 Series Specifications

General

Brand	Samson
Model	373 Series
Category	Valve Positioners
Language	English