Samsung Blu-ray Player - Setting up the Speakeroptions

Press the AT buttons to select the desired audio
option from the options described below, then press
the ENTER or • button.
Press the AT buttons to select the desired item,
then press the ENTER button.
NO l'I_
Press the MENU button to exit the menu.
Digital Output
• PCM : Select this when your equipment does not
decode Dolby Digital.
• Bitstream : Outputs Dolby Digital or MPEG-2 or DTS
audio as bitstream. Select this when your
AV receiver or AV amplifier has a Dolby
Digital or MPEG-2 or DTS Decoder.
NOIi •
Be sure to select the correct Digital Output or
you will hear no sound or a loud noise.
When playing a Dolby Digital movie make sure
the Digital Output is set to Bitstream.
If you have the unit connected via the 5.1
channel analog outputs and play a DVD Dolby
Digital disc, sound will only be heard from the
Front Left and Right speakers.
If you have the unit connected via any analog
output and play a DTS DVD disc, no sound
will be heard. To hear sound, the digital output
must be connected and set to Bitstream.
PCM Down Sampling
• On : Select this when the Amplifier connected to the
player is not 96KHz compatible.
In this case, the 96KHz signals will be down
converted to 48KHz
• Off : Select this when the Amplifier connected to the
player is 96KHz compatible. In this case, all
signals wilt be output without any changes.
_,_olf_ audio though the digital outputs.
HDMI
• If yourTV is notcompatiblewith compressed
multi-channelformats (Dolby Digital, DTS,MPEG), you
should set DigitalAudio to PCM.
• If yourIV is notcompatiblewith LPCMsamplingrates
over 48kHz,youshouldset PCMDownSamplingto On.
Dynamic Compression
This is only active when a Dotby Digital signal is detected.
• Off : You can enjoy the movie with the standard
Dynamic Range.
• On : When Movie soundtracks are played at
low volume or from smaller speakers, the
system can apply appropriate
compression to make low-level content
more intelligible and prevent dramatic
passages from getting too loud.
SettinguptheSpeaker
0ptions
With the unit in Stop mode, press the MENU
button.
Press the AT buttons to select Setup, then press
the ENTER or • button.
Press the AT buttons to select Audio Setup, then
press the ENTER or 1_button.
Press the A_' buttons to select Speaker Setup,
then press the ENTER or 1_ button.
English - 41
,,,>¢+
ISl