LED R&D Lab(VD)
25
0
B
A
A
B
A
D
G
H
*Note: The left and right ends and tops of the wall
mount leaflet are the same as the left and right ends
and tops of the SET
End of SET TOP
End of SET SIDE
4. FRAME installation and cable connection
① Install the wall mount on the wall. (The same method as WALL 2.0)
- Attach the leaflet to the wall to locate the wall mount.
- Check the horizontal state using a laser leveler
- Fix the left and right two points to the wall using the enclosed screw. (According to the leaflet picture)
Fig.1 Using leaflet
Fig.2 using the screw
To Next Page
Loading...
