LED R&D Lab(VD)
36
⑨ Install the SSY BRACKET P-FRONT by hanging it on the ASSY BRACKET P-FRAME. (Note No. 1)
※ Be sure to be aware of the instructions below and install the FRONT.
- Check the cable alignment status of the REAR part before installing the FRONT.
- If the cable is mounted on the part shown below, change the align as shown below. (Fig2)
- Cable damage occurs and overlap between FRONT and REAR occurs when FRONT is installed while the cable is mounted.
Fig.1 careful point Fig.2 Maintain the correct cable align
NG
OK
4. FRAME installation and cable connection
To Next Page
Loading...
