LED R&D Lab(VD)
37
⑨ Install the ASSY BRACKET P-FRONT by hanging it on the ASSY BRACKET P-FRAME. (Note No. 2)
※ Be sure to be aware of the instructions below and install the FRONT.
- Be careful not to collide with the left and right FRONTs when installing FRONTs.
(There is a possibility of module damage)
1. Hang between FRONTs at intervals of 5 to 10mm
2. Don't push too hard when moving left and right of FRONT. Make sure they don't bump into each other.
Fig.1 FRONT gap needs Fig.2 move slowly
Hang it with a gap of more than 5mm
Move slowly
Watch out collisions.
4. FRAME installation and cable connection
To Next Page
Loading...
