LED R&D Lab(VD)
40
SMPS
B’d
SMPS
B’d
LEFT-FRAME
RIGHT-FRAME
⑩ Connect the cable below whenever you hang one ASSY BRACKET P-FRONT to the P-FRAME. (130”)
- After creating a space by pulling the bottom of the P-FRONT, connect the OCM cable to the CN311 of the BN41-03167A board
- After attaching P-FRONT to P-FRAME, connect BN41-03167A of P-FRONT and BN41-03167A of P-FRAME
- The pile of cables exposed to the bottom of the set is pushed into the gap between P-FRONT and P-FRAME
Lower Interface
4. FRAME installation and cable connection
Fig.1 Securing space at the
bottom of FRONT
Fig.2 Connect OCM cable
OCM cable
To Next Page
Loading...
