LED R&D Lab(VD)
38
⑨ Lift the ASSY BRACKET P-FRAME using BRACKET-HANDLE. (Note No. 3)
※ Be sure to be aware of the instructions below and install the FRONT.
- Insert HANDLE into FRAME as shown in Figure 1.
- Push it in the direction of the FIG.2 arrow to fix it. (* Be careful of direction, be sure to fix it in the guided direction.)
- Fix two per worker and lift at the same time.
Fig.1 handle point Fig.2 fixing handle
HANDLE
TOP
BOT
※ caution : when using a handle, use a hole that narrows in the TOP direction.
Be sure to be careful because using a hole that narrows in the direction of BOT
can shock the product. (Refer to the figure above)
Do not use a hole that
narrows in the direction
of BOT
Use a hole that narrows in the
TOP direction
4. FRAME installation and cable connection
To Next Page
Loading...
