s30nmdl2sm-REV0808 Model S30 Non-Metallic Page 10
RECYCLING
Many components of SANDPIPER
®
AODD
pumps are made of recyclable materials (see
chart on page 11 for material specifi cations).
We encourage pump users to recycle worn
out parts and pumps whenever possible, after
any hazardous pumped fl uids are thoroughly
fl ushed.
CE
This pump is pressurized
internally with air pressure
during operation. Always
make certain that all bolting
is in good condition and
that all of the co rre ct
bolting is reinstalled during assembly.
WARNING
Before pump operation,
i n s p e c t a l l g a s k e t e d
fasteners for looseness
caused by gasket creep. Re-
torque loose fasteners to
prevent leakage. Follow recommended torques
stated in this manual.
CAUTION
When used for toxic or
aggressive fl uids, the pump
should always be fl ushed
clean prior to disassembly.
WARNING
B e f o r e m a i n t e n a n c e
or r epa i r, shut o f f the
c o m p r e s s e d ai r l i n e ,
bleed the pressure, and
disconnect the air line from
the pump. The discharge line may be pressurized
and must be bled of its pressure.
WARNING
WARNING
Airborne particles and
loud noise hazards.
Wear ear and eye
protection.
B e f o r e d o i n g a n y
maintenance on the pump,
be certain all pressure is
completely vented from the
pump, suction, discharge,
piping, and all other openings and connections.
Be certain the air supply is locked out or made
non-operational, so that it cannot be started
while work is being done on the pump. Be certain
that approved eye protection and protective
clothing are worn all times in the vicinity of the
pump. Failure to follow these recommendations
may result in serious injury or death.
WARNING
WARNING
In the event of diaphragm
rupture, pumped material
may enter the air end of the
pump, and be discharged
into the atmosphere . If
pumping a product which is hazardous or toxic,
the air exhaust must be piped to an appropriate
area for safe disposition.
IMPORTANT SAFETY
INFORMATION
IMPORTANT
Read these safety warnings
and instructions in this
manual completely, before
installation and start-up
of the pump. It is the responsibility of the
purchaser to retain this manual for reference.
Failure to comply with the recommendations
stated in this manual will damage the pump,
and void factory warranty.
Read these safety warnings
and instructions in this
manual completely, before
installation and start-up
of the pump. It is the responsibility of the
purchaser to retain this manual for reference.
Failure to comply with the recommendations
stated in this manual will damage the pump,
and void factory warranty.
Pump complies with EN809 Pumping Directive,
Directive 98/37/EC Safety of Machiner y.
For reference to the directive certifi cates visit:
www.warrenrupp.com.
To Next Page
Loading...
Need help?
General
