Selecting the Input Source
Press the 1. Source button to display the input source list.
Press the 2.
buttons to select the input source that you want: DTV / TV /
SCART / AV / Component / VGA / HDMI1 / HDMI2 / HDMI3 / HDMI4 / DMP.
Press the 3. OK button to confirm your selection.
Alternative
Press the • TV/DTV button to switch the input source between TV
and DTV.
Press the • Radio button to switch to digital radio channels directly.
Press it again to return to the previous DTV channel.
Press the • DMP button to switch to DMP mode directly.
A pop-up screen will be displayed. Press the 9. buttons to
select the following options and the
buttons to adjust the
setting.
Country selection To select the country where you will operate
the TV.
Add channel only Yes To only add channels to the existing
channel list.
No To retune and overwrite the
existing channel list. (It is always
recommended to select "No")
Press the 10.
button to select Start on the screen and then
press the OK button to start the auto tuning. Auto tuning will
commence. This operation may take up to 15 minutes. The
display will show the progress of the tuning and the number
of channels found. After auto tuning is complete, the first DTV
channel tuned will be displayed on screen.
Press the 8. button to highlight Auto Install and then press the
OK button or the
button to confirm.