EasyManua.ls Logo

SANY SRT55D - Maintenance Inspection Form for 1350 Hrs

SANY SRT55D
268 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SRT55D Off-Highway Truck
8-49
Safety, Operation and Maintenance Manual
8.6.14 Maintenance inspection form for 1350hrs
Except daily (10hrs) inspection projects, the following projects also have to nish after running
1350hrs.
1. For normally checking
Check leakages, loosened and damaged parts for truck.……….........…………………………
Observe the cracks and welder seam for frame……………................................................
2. Cummins engine
Check the fasteners for engine………………………………………...........................…………
Check PTO liquid level, rell as required……………………..…………..............………………
3. Transmission
Clean the breather assembly for transmission and lubricates again.……...........……..………
Check status about block caution lamp for lter.……………………................................…….
Remark:
drain, replace lter and rell after 150hrs, if transmission has been xed.
4. Main reducer and differential assembly,planetary assembly and power take-off (PTO)
Change the lubrication of Main reducer and differential assembly,planetary assembly and PTO.
.....................................................................................................................................
Check liquid level, rell as required…………………………………………......…………………
Check and clean the breather assembly for rear shaft.………………..............………………
Check and clean the breather assembly for PTO……………………….............…………...…
Remark:
change oil when replace new one or after xed.
5.The scene did not conduct the driveline assembly bolts inspection requirements (The rst 150
hours, After every 1200 hours)
Front driveline bolts tightening torque:145N.m……………………………………......…………
Rear driveline bolts tightening torque:260N.m……………….……………………......…………
Front driveline bolts check torque:140N.m……………………...…………………......…………
Rear driveline bolts check torque:250N.m…………………………………………......…………
6. Clean up the dust on the pin shaft of foot-operated valve,and add the lubricating oil.……
7.Check the driveline bolts torque(rst time after 150hrs, next time after each 1200hrs)…...
Use of the site Tightening torque Check torque
Front driveline 145 140
Fear driveline 260 250
Checker Date
Remarks
Lubrication and Servicing
Courtesy of Machine.Market

Table of Contents