SANY SRT55D - Maintenance Inspection Form for 3000 Hrs

SRT55D Off-Highway Truck
8-83
Safety, Operation and Maintenance Manual
8.6.29 Maintenance inspection form for 3000hrs
Except daily (10hrs) inspection projects, the following projects also have to nish after running
3000hrs.
1. For normally checking
Check leakages, loosened and damaged parts for truck.……….........…………………………
Observe the cracks and welder seam for frame……………................................................…
Check displacement and worn for transmission shaft by lever.……….....................…….……
2. Lubrication
Front, rear transmissions cross shafts………………….……......................…..................…..6 points
Front, rear transmission shafts…………………………………………......…….................…..2 points
universal joint of steering rod.....………………….……......................….................………….3 points
Hands lubrication system
Check and clean the grease lter element……………........................................................…
3. Electrical system
Check harnesses status.………………………………..................………………………………
Check status about cables for storage battery……………………………………………………
4. Cummins engine
Check fasteners for engine, tighten them if required………………...........................…………
Check oil level for PTO, rell as required.………………..…………...................………………
Drain, replace lter and rell.………………………………………….....…………………………
Check breather assembly for crankcase........................…………….…………………..………
Fuel system
Replace fuel lter…………………………………………………………………….………………
Cooling system
Replace coolant lter………………………………………………………………………..………
Check and supplement DCA to coolant…………….….......................................................….
Air cleaner
Clean pipeline and lter for air cleaner.…………….…........................................................….
5. Transmission
Check the status of the pin of injector, tighten it if required.…….........................……..………
Clean the breather assembly for transmission and lubricates again.……...........……..………
Check status about block caution lamp for lter.……………………................................…….
Remark:
drain, replace lter and rell after 150hrs, if transmission has been xed.
6. Main reducer and differential assembly,planetary assembly and power take-off (PTO)
Extract lubrication sample from Main reducer and differential assembly and planetary assembly
for checking and analysis……………………………………………………......…………………
Check liquid level, rell as required…………………………………………......…………………
Check and clean the breather assembly for rear shaft.………………..............………………
Check and clean the breather assembly for PTO……………………….............…………...…
Remark:
change oil when replace new one or after xed.
7. Front brake system
Check status about disc worn to determinate replace it if required……..............…………...…
Lubrication and Servicing
Courtesy of Machine.Market