SANY SRT55D - Maintenance Inspection Form for 1500 Hrs

SRT55D Off-Highway Truck
8-51
Safety, Operation and Maintenance Manual
8.6.15 Maintenance inspection form for 1500hrs
Except daily (10hrs) inspection projects, the following projects also have to nish after running
1500hrs.
1. For normally checking
Check leakages, loosened and damaged parts for truck.……….........…………………………
Observe the cracks and welder seam for frame……………................................................…
2. Cummins engine
Check the fasteners for engine………………………………………...........................…………
Check PTO liquid level, rell as required……………………..…………..............………………
Drain, replace lter and rell………………………………..................………………………..…
Check breather assembly for crankcase………………………................………………………
Fuel system
Replace fuel lter…………………………………………………………………….………………
Cooling system
Replace coolant lter………………………………………………………………………..………
Check and supplement DCA to coolant…………….….......................................................….
3. Transmission
Check the status of the pin of injector, tighten it if required.…….........................……..………
Clean the breather assembly for transmission and lubricates again.……...........……..………
Check status about block caution lamp for lter.……………………................................…….
Remark:
drain, replace lter and rell after 150hrs, if transmission has been xed.
4. Front brake system
Check status about disc worn to determinate replace it if required.……....……………………
5. Main reducer and differential assembly,planetary assembly and power take-off (PTO)
Extract lubrication sample from Main reducer and differential assembly and planetary assembly
for checking and analysis....................................................................................................…
Check liquid level, rell as required…………………………………………......…………………
Check and clean the breather assembly for rear shaft.………………..............………………
Check and clean the breather assembly for PTO……………………….............…………...…
Remark:
change oil when replace new one or after xed.
6. Lubrication
Front, rear transmissions cross shafts…………….......................…………..................……..6 points
Front, rear transmission shafts………………………….......………………….................…….2 points
7.Hydraulic system
Replace new lter for the return lter of hoisting system……………….............…………....…
Replace new lter for the return lter of steering system……………….............…………...…
Replace new lter for the lter which mounted on the pipeline of the steering system…....…
Replace new lter for the lter which mounted on the pipeline of the cooling system.……….
Replace the lter which mounted inside of the rear braking valve group........……………....…
Replace the breath valve for the steering hydraulic tank………………...........….………....…
Replace the breath valve for the hoisting hydraulic tank……………….............…………....…
Lubrication and Servicing
Courtesy of Machine.Market