SANY SRT55D - Alternate Exit; Ensure Good Visibilty

Safety
Safety, Operation and Maintenance Manual
2-21
SRT55D Off-Highway Truck
2.2.21 Alternate exit
●
If you are unable to open the cab door
in case of emergency, use the safety
hammer to break the rear window to
escape.
●
Remove the pieces of glass from the
window frame before escaping. Be
careful not to be cut by broken glass.
Pay attention to the broken glass on the
ground, which may cause you to slip and
fall.
2.2.22 Ensure good visibilty
This machine is equipped with mirrors to
improve the visibility, but even with mirrors,
there are places, which cannot be seen from
the operator’s seat, so always be careful when
operating.
When operating or traveling in places
with poor visibility, if it is impossible to conrm
the condition of the job side or obstacle is in
the area around the machine, there is danger
that the machine may suffer damage or the
operator may suffer serious personal injury.
Whenoperating or traveling in places with poor
visibility, always observe the following items
strictly.
●
If the visibility cannot be sufficiently
assured, position a flagman if necessary.
The operator should pay careful attention
to the signs and follow the instructions of
the flagman.
●
The signals should be given only by one
flagman.
●
When working in dark places, turn on
the working lamps and front lamps of
the machine, and if necessary, set up
additional lighting in the area.
●
Stop operations if there is poor visibility,
Fig. 2.2-20
Fig. 2.2-21
Danger
Courtesy of Machine.Market