SANY SRT55D - Maintenance Inspection Form for 6000 Hrs

SRT55D Off-Highway Truck
8-115
Safety, Operation and Maintenance Manual
8.6.42 Maintenance inspection form for 6000hrs
Except daily (10hrs) inspection projects, the following projects also have to nish after running
6000hrs.
1. Engine PTO
Disassemble, inspect and x or replace some parts if required which parts has been worn.………
………............................................................................................................................…….
Check Pin Spindle and Bush ,replace them as required…………………........................…….
2. Hoist cylinder
Disassemble, inspect and x or replace some parts if required which parts has been worn.………
………............................................................................................................................…….
Check Pin Spindle and Bush ,replace them as required…………………........................…….
3. Front, rear ride cylinder
Disassemble, inspect and x or replace some parts if required which parts has been worn.………
………............................................................................................................................…….
Check Pin Spindle and Bush ,replace them as required…………………........................…….
4. Steering connecting-rod gear
Check and x or replace some parts if required which parts has been worn.....………………
5. Steering cylinder
Dismounting ,checking and repair or replace damaged components for the cylinder if requir
ed......................................................................................……............……............................
Check the pins and bearings or replace damaged parts for the cylinder if reqiured...............
6. Oil cooling unit
Disassembly, xing and reassembly…………...………………………………………………….
7. Radiator
Disassembly, xing and reassembly………………...…………………………………………….
Transmission shaft
Check and fix or replace some parts if required which parts has been worn.………….
Check balance.……………………………………………………………………..........………….
9. Body
Replace lining plate as required.............................................……………………………….….
Replace Pin Spindle and Bush as required…........................……………………………….….
10.Rear Axle
Replace a frame, drag link and bush…...........................................………………………...…
11.Transmission
Check fasteners for spray equipment, fasten as required ..................…………………………
12. Clean up the dust on the pin shaft of foot-operated valve,and add the lubricating oil...…
Lubrication and Servicing
Courtesy of Machine.Market