SANY SRT55D - Maintenance Inspection Form for 3150 Hrs

SRT55D Off-Highway Truck
8-87
Safety, Operation and Maintenance Manual
8.6.30 Maintenance inspection form for 3150hrs
Except daily (10hrs) inspection projects, the following projects also have to nish after running
3150hrs.
1. For normally checking
Check leakages, loosened and damaged parts for truck.……….........…………………………
Observe the cracks and welder seam for frame……………................................................…
2. Cummins engine
Check the fasteners for engine………………………………………...........................…………
Check PTO liquid level, rell as required……………………..…………..............………………
3. Transmission
Clean the breather assembly for transmission and lubricates again.……...........……..………
Check status about block caution lamp for lter.……………………................................…….
Remark:
drain, replace lter and rell after 150hrs, if transmission has been xed.
4. Main reducer and differential assembly,planetary assembly and power take-off (PTO)
Extract lubrication sample from Main reducer and differential assembly and planetary assembly
for checking and analysis……………………………………………………......…………………
Check liquid level, rell as required…………………………………………......…………………
Check and clean the breather assembly for rear shaft.………………..............………………
Check and clean the breather assembly for PTO……………………….............…………...…
Remark:
change oil when replace new one or after xed.
5. Clean up the dust on the pin shaft of foot-operated valve,and add the lubricating oil.……
Checker Date
Remarks
Lubrication and Servicing
Courtesy of Machine.Market