37
5. Wireless LAN Configurations
Computer environment and Wireless LAN connection;
Wireless LAN with Easy setting connection will be made via AdHoc IEEE802.11b mode. For
setting contents, refer to "Wireless LAN factory default settings". (p38)
With the Easy setting, computer's LAN environment setting will be switched to the settings on
p38. Because of that, the LAN cannot work for the other operation while using
"NetworkModule Client" or "NetworkModule Moderator".
After terminating the application, the LAN environment will automatically go back to the
previous state.
Display the current LAN connecting environment. Select "Wireless Information" (p35) and press
the SELECT button.
Wireless Factory Default
Select "Wireless Factory Default" from the projector menu (p35) and press the SELECT button.
All the LAN settings will go back to the factory default settings. For details, refer to "Wireless
LAN Factory Default Settings". (p38)
The User PIN code is to restrict the access from the networks to the projector.
After setting the User PIN code, you need to enter it to operate the projector via the networks.
Select "User PIN code" from the projector menu. Set with the same procedures as setting
Wired LAN User PIN code. Refer to "4. Wired LAN Configurations" ➔ "User PIN code". (p30)
NetworkModule Information
MAIN PROGRAM : xxxxx
BOOT PROGRAM : xxxxx
MAC ADDRESS : 08007B650056
IP ADDRESS : 169.254.53.0
SUBNET MASK : 255.255.0.0
GATEWAY ADDRESS : 255.255.255.255
IP CONFIGURATION : DHCP
ARP + PING : Enable
WIRELESS MODE : 802.11b
NETWORK TYPE : AdHoc
CHANNEL : 11
SSID : WIRELESS
WEP : Disable
CONNECTED PC : (None)
English
Wireless Information
User PIN Code
Wireless Information (Example)
To Next Page
Loading...
Need help?
General
