56
7. Project the Image via the Networks
Network Projector
List
Real time Capture button
(While capturing the image, the
button will become Stop Capture
button.)
One-shot Capture button
1. Activate NetworkModule Client (Participants) or NetworkModule Moderator (Moderator).
2. Adjust the projector input to the selected network (Wired or Wireless) with the PJ
Controller. When operating multiple projectors, adjust each projector independently. Refer
to "10. How to Use the PJ Controller". (p73-90)
3. Select a projector from the Network Projector List with a mouse cursor. When selecting
multiple projectors at the same time, press the [Ctrl] key and select projectors with the
mouse cursor. Selected projector will be blue. You can operate up to 5 projectors at the
same time.
4. Click the Real time Capture button to project the computer image in real time.
✳ If the projector has already been being used, "In-use" message will appear on the Network
Projector List. When the "Accept Interruptive Connection" setting is "Enable", you can use
the projector even if it has "In-use" message. When the setting is "Disable", you cannot
use the projector. Refer to "6. Configurations with Browser" ➔ "Advanced Setup" ➔
"Miscellaneous" (p52)
On the Real time Capture screen, the destination projector will be displayed in blue or black.
When Real time capturing has been done, the Real time Capture button will become the Stop
Capture button.
Click the One-shot Capture button to project a copied still picture of the computer screen.
The quality or transmission speed of the projected picture can be set through Advanced
settings. Click the Advanced settings button to display the menu. Select "Quick" or "Clear" with
the check button.
When selecting "Quick", the image transmission speed will be quicker but the image quality will
be lower. When selecting "Clear", the image quality will be better but the transmission speed
will be slower.
When the User PIN code has been set, User PIN code screen will appear after clicking the
Capture buttons. If multiple projectors have different PIN codes, you need to enter PIN codes for
every projector. To set the User PIN code, refer to "4.Wired LAN setting" ➔ "Set the User PIN
code" (p30), "6. Configurations with Browser" ➔ "Advanced Setup" ➔ "User PIN code" (p50).
The same procedure will be required when operating via Moderator screen (NetworkModule
Moderator). While projecting the image in real time, the projector cannot be operated via PJ
Controller or browser.
✳ The projector cannot be connected to via the networks while using the viewer.
PJ Controller button
To Next Page
Loading...
Need help?
General
