81
10. How to Use the PJ Controller
PC adjustment
This feature optimizes the signal from the
connected computer to display the screen.
✳ PC adjustment screen is displayed only when
Computer1 (Analog) or Computer 2 (RGB) is
selected for the input source.
Parameter Description
Current Mode ..................Display computer mode
Auto PC adjustment..........Executed by clicking Start button.
Fine sync ..........................Click 7 8 to adjust the value
Total dots ..........................Click 7 8 to adjust the number to fit your computer image.
H Position ........................Click 7 8 to adjust the horizontal position.
V Position..........................Click 7 8 to adjust the vertical position.
Clamp................................Click 7 8 to adjust the clamp level.
Display Area H ..................Click 7 8 to decrease/increase the value to fit resolution of the image.
Display Area V ..................Click 7 8 to decrease/increase the value to fit resolution of the image.
Load Setting No. ..............Load the preset settings(Mode 1-5)
Save Setting No. ..............You can save the settings of the PC adjustment. Select the mode number you
wish to save and click "Set".
✳ If you want to delete the content in the mode. Select the mode and click
"Mode free".
Comment..........................You can save a note regarding the PC adjustment. Click "Save" to save the note.
English
To Next Page
Loading...
