- 47 -
◆ To enter service mode
To enter service mode, press and hold the "MENU" and
"INPUT" buttons on the projector simultaneously for 5 seconds.
(Or press and hold the "MENU" button on the remote control
unit for 20 seconds.) The "S" mark appears on the screen. While
the "S" mark is displayed on the screen, press and hold the "
POINT UP" and "POINT DOWN" buttons on the projector or
"SCREEN" button on the remote control unit for more than 3
seconds. As shown in a figure, a service mode display appears
on a screen.
◆ To adjust service data
Adjust service data using the following control buttons.
– "OK" ..........................................A group number increases.
– "MENU" ..................................A group number decreases.
– "POINT UP" ..........................An item number increases.
– "POINT DOWN" .................An item number decreases.
– "POINT RIGHT" ..................An adjustment value increases.
– "POINT LEFT" ......................An adjustment value decreases.
◆ To exit service mode
To quit the service mode, press the "POWER ON/STAND-BY"
button only once on the projector or the remote control unit .
● Service Adjustment Menu Operation
Remote Control
Top Control
■ Electrical Adjustment
Normal Mode "S" mark display
MENU
Service Mode
Input VIDEO
Image
Natural
Group No. Data
SANYO
0 +1
R 1.00
ME4A
102
Ver.
Service Mode
Service mode
+
DOWN
POWER
ON/STAND-BY
INPUT
UP
+
S
To Next Page
Loading...
Need help?
General
Weight and Dimensions
