What to do if the Sanyo PLV-Z3000 Projector lamp does not turn on?
If the lamp of your Sanyo Projector doesn't turn on because of a malfunction or because it has reached the end of its life, replace the lamp.
What to do if the temperature inside the Sanyo PLV-Z3000 Projector is abnormally high?
If the temperature inside your Sanyo Projector is abnormally high and the projector cannot be turned on, check and clean the air filters.
What to do if Sanyo Projector detects an abnormal condition and cannot be turned on?
If your Sanyo Projector detects an abnormal condition and cannot be turned on: * Unplug the AC power cord and plug it in again to turn on the projector. * If the projector turns off again, unplug the AC power cord and check it up. * Check the power lines for a power failure.
What to do if Sanyo PLV-Z3000 is operating normally?
No action required.
What to do if the Sanyo Projector is in Power management mode?
No action required.
General| Matrix size | 0.7 \ |
|---|---|
| Vertical scan range | 50 - 100 Hz |
| Horizontal scan range | 15 - 80 kHz |
| Projection technology | LCD |
| Contrast ratio (typical) | - |
| Screen size compatibility | 40 - 300 \ |
| Aspect ratio | 16:9 |
| RS-232 ports | 1 |
| Dimensions (WxDxH) | 400 x 146 x 346 mm |
| Lamp type | UHP |
| Lamp power | 165 W |
| Light source type | Lamp |
| Service life of light source | 2000 h |
| Service life of light source (economic mode) | 3000 h |
| Focus | Manual |
| Focal length range | 22.3 - 45.3 mm |
| Noise level | 19 dB |
| Dot clock scanning frequency | 100 MHz |
| Serial interface type | RS-232 |
| Component video (YPbPr/YCbCr) in | 3 |
Weight and Dimensions| Weight | 7500 g |
|---|
To Next Page
