Sanyo PLV-Z3000 Owner's Manual

24
Input Source and System Selection
Press the INPUT button on the top control or the INPUT buttons on
the remote control (see below) to choose an input source.
Top Control
INPUT button
Press the VIDEO, S-VIDEO, C1, C2, H1, H2, or PC buttons on the
remote control according to the input source.
Remote Control
INPUT buttons on the remote control
INPUT buttons
When the video signal is connected to the VIDEO
jack, press VIDEO.
VIDEO
When the video signal is connected to the S-VIDEO
jack, press S-VIDEO.
S-VIDEO
When the video signal is connected to the
COMPONENT 1 jack, press C1.
C1
When the video signal is connected to the HDMI 1
terminal, press H1.
H1
INPUT button
Video
S-video
PC
When the computer signal is connected to the
COMPUTER connector, press PC.
Component 1
Component 2
HDMI 1
HDMI 2
✔Note:
 •Beforeselectinganinputsourcewiththesebuttons,eachinput
mustbesetonapropersignalformviamenuoperation(seeon
pages25–26).
Computer
✔Note:
 •WhenswitchingfromHDMI1toHDMI2orviceversa,thesignal
maybeinterruptedforamomentdependingontheequipment.
Input
When the video signal is connected to the
COMPONENT 2 jack, press C2.
C2
When the video signal is connected to the HDMI 2
terminal, press H2.
H2

Sanyo PLV-Z3000 Specifications

General

Matrix size	0.7 \
Vertical scan range	50 - 100 Hz
Horizontal scan range	15 - 80 kHz
Projection technology	LCD
Contrast ratio (typical)	-
Screen size compatibility	40 - 300 \
Aspect ratio	16:9
RS-232 ports	1
Dimensions (WxDxH)	400 x 146 x 346 mm
Lamp type	UHP
Lamp power	165 W
Light source type	Lamp
Service life of light source	2000 h
Service life of light source (economic mode)	3000 h
Focus	Manual
Focal length range	22.3 - 45.3 mm
Noise level	19 dB
Dot clock scanning frequency	100 MHz
Serial interface type	RS-232
Component video (YPbPr/YCbCr) in	3

Weight and Dimensions

Weight	7500 g