- 85 -
Indicators
Projector Condition
POWER
red/green/
orange
WARNING
red
LAMP
REPLACE
yellow
The Main On/Off switch is off or the AC power cord is unplugged.
Q
The projection lamp is being cooled down. The projector cannot be turned on
until cooling is completed.
Q
The projector is ready to be turned on with the POWER ON/STAND-BY button.
Q
The projector is operating normally.
Q
The projector is in the Power management mode.
Q
The temperature inside the projector is abnormally high. The projector cannot
be turned on. When the projector is cooled down enough and the tempera-
ture returns to normal, the POWER indicator emits red light and the projector
can be turned on. (The WARNING indicator keeps blinking.) Check and clean
the air filters.
Q
The projector has been cooled down enough and the temperature returns to
normal. When turning on the projector, the WARNING indicator stops blinking.
Check and clean the air filters.
Q
The projector detects an abnormal condition and cannot be turned on.
Unplug the AC power cord and plug it again to turn on the projector. If the
projector is turned off again, unplug the AC power cord and checkup.
Check the power lines. (Power failure)
The lamp does not turn on because malfunction occurs or the lamp reaches
its end of life.
Q
The automatic slide shutter is not working property.
Check the indicators for projector condition.
• • • green
• • • red • • • off
• • • blinking green
Q When the life of the projection lamp draws to an end, the LAMP REPLACE indicator lights yellow. When this indica-
tor lights yellow, replace the projection lamp with a new one promptly. Reset the lamp replacement counter after
replacement of the lamp.
Indicators and Projector Condition
• • • blinking red
Troubleshooting
• • • blinking orange
• • • blinking yellow
To Next Page
Loading...
