Entris
®
BCE Operating Instructions 21
System Settings
Parameter Setting values Explanations
BAUD** 600, 1200,
2400, 4800,
9600*, 19200,
38400, 57600,
115200
Sets the baud rate to the selected value.
PARITY** ODD* Applies an odd parity.
EVEN Applies an even parity.
NONE Does not apply a parity.
STOPBIT** 1 BIT* Sets the number of stop bits to 1.
2 BITS Sets the number of stop bits to 2.
HANDSHK.** SFTWARE Sets the handshake protocol to software handshake.
HARDW. Sets the handshake protocol to hardware handshake.
NONE* Does not set a handshake protocol.
DATABIT** 7 BITS Sets the number of data bits to 7.
8 BITS* Sets the number of data bits to 8.
DEV.USED NONE*,
PRINTER, VIRT.
COM, PC HOST,
REM.DISP.
Indicates which connection is detected at the USB port.
* Factory setting
** Are blocked if “PRINTER” or “REM.DISP.” are displayed under “DEV.USED”
7.3.5 “DEVICE”/”EXTRAS” Menu
Parameter Setting values Explanation
MENU EDITABL.* Activates write access. The menu parameters can be changed.
RD.ONLY Activates read access. The menu parameters cannot be changed.
SIGNAL OFF Switches the acoustic signal off.
ON* Switches the acoustic signal on.
KEYS UNLOCKED* Deactivates the button lock.
LOCKED Activates the button lock.
EXT.KEYB.
PRINT Assigns the print function to the external key.
CAL. Assigns the calibration and adjustment function selected under [CAL./ADJ.] to the external
key.
CF Assigns the [Back] function to the external key.
ENTER Assigns the [Confirm] function to the external key.
ZERO Assigns the [Zero] function to the external key.
TARE Assigns the [Tare] function to the external key.
APP Assigns the [From] function to the external key. The function is triggered for an application
that is not active.
GLP END Assigns the [GLP] function to the external key.
NONE* No function is assigned to the external key.
ON MODE
ON/STDB.* The [On/Off] button switches between on/standby with time.
ON/OFF The [On/Off] button switches between on/standby without time..
AUTO ON Changes the function of the [On/Off] button: The device no longer switches off or to standby
mode, instead it starts a boot process.
* Factory setting
To Next Page
Loading...
Need help?
General