24 Entris
®
BCE Operating Instructions
System Settings
7.3.11 “APPLIC.”/”PERCENT” Menu
Parameter Setting values Explanation
DEC.PLCS NONE The result of the “Weighing in Percent” application is displayed without decimal places.
1 DEC.PL.* The result of the “Weighing in Percent” application is displayed to 1 decimal place.
2 DEC.PL. The result of the “Weighing in Percent” application is displayed to 2 decimal places.
3 DEC.PL. The result of the “Weighing in Percent” application is displayed to 3 decimal places.
* Factory setting
7.3.12 “APPLIC.”/”NET.TOT.” Menu
Parameter Setting values Explanation
PRT.COMP. OFF Deactivates the component printout.
ON* Activates the component printout.
* Factory setting
7.3.13 “APPLIC.”/”TOTAL” Menu
Parameter Setting values Explanation
PRT.COMP. OFF Deactivates the component printout.
ON* Activates the component printout.
* Factory setting
7.3.14 “APPLIC.”/”ANIM.WG” Menu
Parameter Setting values Explanation
ACTIVIT. CALM Sets the intensity of the “Animal activity” to “calm”. Recommended for minor movements of
the sample, e.g. caused by placement on the weighing pan.
MEDIUM* Sets the intensity of the “Animal activity” to “medium”. Recommended for medium movements
of the sample, e.g. caused by placement on the weighing pan.
V.ACTIVE Sets the intensity of the “Animal activity” to “very active”. Recommended for very active
movements of the sample, e.g. caused by placement on the weighing pan.
START MANUAL The “Animal weighing” application must be manually selected in the start screen.
AUTO* Sets the trigger to start the “Animal weighing” application to “automatic”.
* Factory setting
7.3.15 “APPLIC.”/”CALC.” Menu
Parameter Setting values Explanation
METHOD MUL.* Specifies multiplication as the method of calculation for the “Calculation” application.
DIV. Specifies division as the method of calculation for the “Calculation” application.
* Factory setting
To Next Page
Loading...
Need help?
General