Sartorius FC - Setting the Application Parameters; Features

Setting the Application Parameters (Application)
Purpose
This menu item enables you to
configure the scale, i.e., adapt the scale
to your individual requirements by
selecting from a list of parameter
options in a menu. You can block
access to this menu by assigning a
password.
Features
The simple weighing function is
available at all times. You can select
one from each of the following
application groups. This means a
number of combinations are possible.
Application 1 (basic settings)
– Toggle weight units
– Counting
– Weighing in percent
– Animal weighing (averaging)
– Recalculation
– Calculation
– Density determination
– Differential weighing
Application 2 (control functions)
– Checkweighing
– Time-controlled functions
Application 3 (data records)
– Totalizing
– Formulation
– Statistics
In addition, you can assign 2 extra
functions to each of the soft keys, in
some cases (depending on the Setup
configuration):
– Second tare memory
– Identification codes
– Manual storage M+ key
– Product data memory
Auto-start application the scale
is switched on
Factory settings:
only application parameters
Factory Settings
The factory settings are identified by
the symbol "ο" in the list starting on
the next page.
Preparation
Display available application
parameters:
§ Select the Setup menu:
press the H key
> SETUP is displayed
§ Select parameters: repeatedly press
the
q and O soft keys
If you have already assigned a
password:
> The password prompt is displayed:
$ If access is blocked by a password:
enter the password using the numeric/
alphabetic keys
$ If the last character of the password is a
letter: conclude input by pressing a
§ Confirm your password and have the
application parameters displayed:
press the
l soft key
> The application menu is displayed:
$ To select the next group:
press the q soft key (down arrow)
$ To select the previous item of a group:
press the
Q soft key (up arrow)
$ To select the next sub-item within
a group: press the
O soft key
(right arrow)
$ To select the previous group:
press the
o soft key (left arrow)
$ To confirm: press the
l soft key
Extra Functions
§ Exit the Setup menu:
press the
oo soft key
> Restart your application
§ Print parameter settings:
– When the scale functions are displayed,
press p
> Printout (example)
Texts with more than 20 characters are
truncated
SETUP
APPLICATION
--------------------
Application 1 (basi
Off
Application 2 (cont
Off
Application 3 (data
Off
Extra function (F4)
2nd tare memory
Container tare we
No
Automatic printou
Off
Extra function (F5)
Off
Auto-start app. whe
Off
--------------------
17