Formulation
M
Purpose
With this application program you
can add weight values and calculated
values as components of a formula
to a totalizing memory.
You can use this application in
combination with any program
chosen from Application 1* (such as
counting, weighing in percent) and
one from Application 2 (checkweighing,
time-controlled functions) as well as
with the extra functions.
*= not with recalculation or 2
nd
tare
memory; cannot be activated during
formulation
Available Features
– Totalization of weight values and
calculated values
– Weigh in different components toward
zero to a total amount defined by
pressing the
Nom soft key and entering
the value through the numeric keys
– Simultaneous storage of net and
calculated values, if available
– Optional configuration in the Setup
menu for loading weight values
and calculated values either from
Application 1 (e.g., counting, weighing
in percent) or from Application 2
(checkweighing, time-controlled
functions)
– Totalizing memory for up to 65,535
values
– Transaction counter and current total
displayed in the text line
– Scale tared after a value has been
stored
– Manual input of the number of
individual weighing operations and
confirmation using the
nDef soft key
(target no. of operations nDef). Result
printed and memory cleared after
printout of nDef.
– Optional configuration in the Setup
menu to add the current weight, with
display accuracy, to the current total
by pressing the
M+ soft key and
generating a printout of the result
– Optional configuration in the
Setup menu for stability-dependent
storage of the measured value:
Balance/scale functions, Stability range
– Optional automatic storage of
measured values
Storage of measured value is indicated
by
Uu; zz indicates that you can
place a load on the scale.
– Minimum load threshold for automatic
storage
– Press the
M- soft key to delete the last
value added to the totalizing memory.
The transaction counter value is
reduced by one and a printout is
generated.
– Printout of an evaluation of results,
depending on the Application 1 or
Application 2 parameters. Configure the
Setup menu to define the information
included on this printout.
– Press the key identified by
MR (soft
key) for a printout of an intermediate
evaluation after each addition or a
final evaluation
– A final evaluation is printed when the
formulation routine is ended
by pressing c, if no final evaluation
was generated by pressing
MR
– Optional configuration in the Setup
menu to clear the totalizing memory
and reset the transaction counter by
pressing c or after an evaluation is
printed out
– Totalization data and transaction
counter data are stored in the
non-volatile memory
– Continue formulation after turning
the scale off and back on
Factory Settings of the Paramters
Automatic storage:
Off
Minimum load for automatic storage:
10 digits
Source of data for auto storage:
Application 1
Evaluated values: Net
Evaluation mode, MR key function:
Intermediate
evaluation, print
Printout of individual components: Yes
Stability range: 2 digits
Printout: Application-defined output:
Print on request then tare:
Off
Soft Key Functions
M+ Add weight values or
application values to the total
in the totalizing memory.
The component or transaction
counter value increases by one
each time you press this key.
M- Delete the last value added
to memory. The transaction
counter value decreases by 1.
You cannot delete previous
values by repeatedly pressing
this key.
MR Print or display an inter-
mediate or final evaluation
nDef Store the input number of
components
Nom Press to enter target
component weight using
the numeric keys
Printout of Formulation Report
When an intermediate or final evaluation
is printed out, all results up to this point
are included.
Comp2 + 42.38 g
Tot.cp+184.89 g
Comp2: Weight of the 2nd component
Tot.cp: Total of all components
76
To Next Page
Loading...
