Sartorius FC - Page 67

67
Preparation
● Turn on the scale: press e
> The Sartorius logo is displayed; a self-test is performed
● Select the “Checkweighing” application in the Setup menu: press H
● Select the
Application parameters: press the q soft key 2+,
then the
O soft key
● Select
Application 2 (control functions):
Press the
q soft key, then the O soft key
● Select
Checkweighing: press the Q or q soft key, repeatedly, if necessary
● Confirm
Checkweighing: press the O soft key
Checkweighing Activation of port lines o Within checkweighing range
Always on
Stability and checkweighing range
At stability
Stability + checkweighing range
–> once
Type of o Target, min, max weight
checkweighing input Min, max weight
Target, min in %, max in %
Weight display mode o Absolute value
Difference from the target
Automatic printout Yes
of OK values o No
o = factory setting
see also the “Application Parameters (Overview)” in the chapter entitled “Configuration”
● Save settings and exit the Setup menu: press the
oo soft key
Additional Functions
In addition to the functions for:
– alphanumeric input, (not during
initialization),
– taring (not during alphanumeric input)
– printing,
you can also access the following
functions from this application:
Calibration/Adjustment
● Press the
isoTST soft key
> See “Calibration/Adjustment” for
further instructions
Toggling to Another Application
● Press D
> See the section on the corresponding
application program for further
instructions
Setup (Setting Parameters)
● Press H
> See “Configuration” for further
instructions
Turning Off the Scale
● Press e
> The scale shuts off