Sartorius FC - Page 73

73
Preparation
● Turn on the scale: press e
> The Sartorius logo is displayed; a self-test is performed
● Select the “Totalizing” application program in the Setup menu: press H
● Select the
Application parameters: press the q soft key 2+,
then the
O soft key
● Select
Application 3 (data records): press the q soft key 2+,
then the
O soft key once
● Select
Totalizing: press the Q or q soft key
● Confirm
Totalizing: press the O soft key
Totalizing Automatic storage ο Off
On, first value at stability
On, last value at stability
On, value bet. 70 - 130% at stabil.
Minimum load for None
automatic storage ο 10 digits
20 digits
50 digits
100 digits
200 digits
500 digits
1000 digits
Source of data ο Application 1
for automatic storage Application 2
Evaluated values ο Net
Calculated
Net + calculated
Evaluation mode, ο Intermediate evaluation, print
MR function Final evaluation, print
Intermediate evaluation, display + print
Final evaluation, display + print
M+/M– function, ο Off
then tare On
Printout of individual No
components ο Yes
ο = factory setting
see also the “Application Parameters (Overview)” in the chapter entitled “Configuration”
● Save settings and exit the Setup menu: press the
oo soft key
Additional Functions
In addition to the functions for:
– alphanumeric input,
– taring (not during alphanumeric input),
– printing,
you can also access the following
functions from this application:
Calibration/Adjustment
● Press the
isoTST soft key
> See “Calibration/Adjustment” for
further instructions
Toggling to Another Application
● Press D
> See the section on the corresponding
application program for further
instructions
Setup (Setting Parameters)
● Press H
> See “Configuration” for further
instructions
Turning Off the Scale
● Press e
> The scale shuts off