111
Checkweighing with statistical evaluation
You want to check a piece count, and have the results that lie within the tolerance range statistically evaluated and printed as a ISO/GLP-com-
pliant record.
Settings (changes in the factory settings required for this example):
Setup: Application parameters: Application 1: Counting
Setup: Application parameters: Application 2: Checkweighing
Setup: Application parameters: Application 3: Statistics: Automatic storage: On, first value at stability
Setup: Application parameters: Application 3: Statistics: Source of data for auto storage: Application 2
Setup: Application parameters: Application 3: Statistics: Evaluated value: Calculated
Setup: Application parameters: Application 3: Statistics: Evaluation mode, MR function: Intermediate evaluation, display+print
Setup: Application parameters: Printout configuration: ISO/GLP/GMP printout: Always
Step Key (or instruction) Display/Output
1. If necessary: turn on the balance e
and enter the settings given above
2. Place reference sample quantity Place parts on the balance
on the balance
3. Initialize the balance
Start soft key
4. Remove reference sample quantity Unload the balance
5. Initialize Checkweighing
Toggle to Checkweighing d
Examples of Application Combinations
--------------------
18.03.1997 09:41
SARTORIUS
Mod. LA4200S
Ser.-no. 60419914
Ver.-no. 01-35-18
ID
---------------------
C-ID
nRef 10 pcs
wRef 21.03500 g
n1
Qnt + 10 pcs
To Next Page
Loading...
Need help?
General
