97
Second Tare Memory
(Preset Tare)
Purpose
With this function you can store the
weight currently on the balance as a
tare weight, or use the numeric keys to
enter a number for a preset tare weight.
You can use “Extra Functions” in
combination with a program from
Application 1 (e.g., counting, weighing
in percent), one from Application 2
(checkweighing, time-controlled
functions) and one from Application 3
(totalizing, formulation, statistics)
as well as with the extra functions.
Available Features
– Store a weight on the balance in the
second tare memory (without numeric
input)
– Store a numeric value in the second tare
memory (input using the numeric keys)
– Label a net value as s
1 when there
is a value stored inthe second tare
– You can assign this function to the
fourth or fifth soft key (from the right),
i.e. F4 or F5
The soft key designation for this
function is:
PT1/T1
– Optional configuration in the Setup
menu for storing the current weight
readout as the container tare weight.
Any load subsequently placed on the
scale that is more than 70% of the tare
weight is automatically recognized
as a container and the scale is tared
automatically.
– Automatic printout when a value is
stored or input (see “Configuration”)
– Press c to delete the (preset) tare
value
Additional Functions
Factory Settings
Container tare weight:
No
Automatic printout: Off
Soft Key Functions
PT1/T1 Store weight as tare value
PT1 Save tare weight entered
using the numeric keys
Printout of the Data in the 2nd Tare
Memory
The printout shows either
– Net value N1
– Tare weight T1, or
– Manually entered tare value PT1
N1 163.48 g
T1 138.73 g
PT1 150.00 g
N1: Net weight /value) when a weight
is stored in the tare memeory
T1: Tare weight
PT1: Preset tare value entered using
the numeric keys
Preparation
G Turn on the balance: Press e
> Sartorius logo is displayed
G Select Extra function (F4) or Extra function (F5) in the Setup menu: Press o
G Select
Application parameters: press the q soft key 2 +,
then the
O soft key once
G Select
Extra function (F4) or Extra function (F5): press
the
q soft key 3 +, then press the O soft key once
G Select
2nd tare memory
G Confirm 2nd tare memory
2nd Container tare ο No
tare memory weight Yes
Automatic Net value
printout Tare/preset tare
ο Off
o = factory setting
see also “Application Parameters (Overview)” in the chapter entitled “Configuration”
G Save settings and exit the Setup menu: press the
oo soft key
Second Tare Memory in Legal Metrology
– Press the
(i)PT1 soft key to enter information about the tare value using the number
keys.
– The PT1 tare value is printed out with the net value.
To Next Page
Loading...
Need help?
General
