Storage and Shipping Conditions
– Do not expose the balance to extreme
temperatures, jolts, impacts, vibration or
moisture.
Unpacking the Balance
G After unpacking the balance, check it
immediately for any visible damage as
a result of rough handling during
shipment.
$ If this is the case, proceed as directed
in the chapter entitled “Care and
Maintenance,” under the section on
“Safety Inspection.”
It is a good idea to save the box and
all parts of the packaging until you have
successfully installed your
balance. Only
the original packaging
provides the best
protection for shipment. Before packing
your balance, unplug all connected
cables to prevent damage.
Important Note Concerning Verified
Balances Approved for Use as Legal
Measuring Instruments in the EU*:
Provided that an official seal is required
for the verified balance, a control seal is
affixed to the balance. This seal will be
irreparably damaged if you attempt
remove it. If the seal is broken, the
validity of the verification will become
void and you must have your balance
re-verified.
* including the Signatories of the Agree-
ment on the European Economic Area
7
Getting Started
Equipment Supplied
The equipment supplied includes the
components listed below:
LA balances with a readability
of 0.1 mg
– Balance with display and control unit
– AC adapter
– Dust cover
– Bushing
– Shield plate
– Shield disk
– Weighing pan
– USB interface cable
LA balances with a readability of 1 mg
– Balance with display and control unit
– AC adapter
– Dust cover
– Shield disk
– Pan support
– Weighing pan
– Glass draft shield cylinder
– Draft shield cover
– USB interface cable
LA8200S, LA8200P, LA 6200S,
LA 4200S, LA 2200S, LA 820,
LA 420, LA 2200P, LA 5200P
– Balance with display and control unit
– AC adapter
– Dust cover
– Pan draft shield
– Weighing pan
– USB interface cable
LA 12000S, LA 6200, LA 4200,
LA 2200, LA 12000P
– Balance with display and control unit
– AC adapter
– Dust cover
– Weighing pan
– USB interface cable
LA balances with a capacity >16 kg
– Balance with display and control unit
– AC adapter
– Dust cover
– Weighing pan
– Dust cover for the display and control
unit
– USB interface cable
Installation Instructions
When choosing a location to set up
your balance, observe the following so
that you will be able to work with
added speed and accuracy:
– Avoid placing the balance in close prox-
imity to a heater or otherwise exposing
the balance to heat or direct sunlight
– Protect the balance from drafts hat
come from open windows or doors
– Do not expose the balance to extreme
moisture over long periods
– Avoid exposing the balance to extreme
vibrations during weighing
– Set up the balance on a stable, even
surface
– Protect the balance from aggressive
chemical vapors
Conditioning the Balance
Moisture in the air can condense on
the surfaces of a cold balance whenever
it is brought into a substantially warmer
place. If you transfer the balance to a
warmer area, make sure to condition it
for about 2 hours at room temperature,
leaving it unplugged from AC power.
To Next Page
Loading...
Need help?
General
