11
Fastening an Antitheft Locking Device: Balances with a Weighing Capacity <12 kg
To fasten an antitheft locking device, use the lug located on the rear panel of the balance.
G Secure the balance at the place of installation, e.g., with a chain or a lock.
Leveling the Balance
Purpose:
– To compensate for unevenness at the place of installation
– To achieve perfectly horizontal positioning of the balance for consistent reproducibility
Always level the balance again any time it is moved
Leveling Balances with a Weighing Capacity <12 kg
Only the 2 front feet are used for leveling.
G Retract the 2 rear feet (only for models with rectangular weighing pan)
G Turn the 2 front feet as shown in the illustration until the air bubble is centered within
the circle of the level indicator
> Several leveling steps are usually required.
G When weighing heavy samples (or when the YDH 01 LP display arm is attached):
Extend the 2 rear feet until they touch the surface on which the balance rests
Leveling Balances with a Weighing Capacity >16 kg
G Adjust the four leveling feet until the air bubble is centered within the circle of the level
indicator
Setting the Language
> See the “Setting the Language” section in the chapter entitled “Configuration”
Setting the Date and Time
> See the “Entering Date and Time” section in the chapter entitled “Configuration”
To Next Page
Loading...
Need help?
General
