50
Additional Functions
In addition to the functions for:
– alphanumeric input,
– taring (not during alphanumeric input),
– printing (NUM print; S ID), you can also
access the following functions from this
application:
Calibration/Adjustment
G Press the
Cal soft key
> See “Calibration/Adjustment” for
further instructions
Toggling to the Next Application
G Press d
> See the section on the corresponding
application program for further
instructions
Setup (setting parameters)
G Press o
> See “Configuration” for further
instructions
Turning Off the Balance
G Press e
> The balance shuts off
Practical Example
Toggle the Display From Grams [g] (1st Unit) to Troy Ounces [ozt] (2nd Unit)
Settings (changes in the factory settings required for this example):
Setup: App: Application 1: Toggle wt. units: Weight unit 2: Troy ounces /ozt
Step Key (or instruction) Display/Output
1. Toggle back to weight unit 1, c
if necessary (
(: Weight unit 1)
2. Change weight unit
ozt soft key
to Troy ounces [ozt]
(
): Weight unit 2)
3. Change weight unit
g soft key
to Grams [g]
To Next Page
Loading...
Need help?
General
