70
Printout for Differential Weighing
Generating Printouts
Automatically
The configured backweighing printout
is generated automatically after
backweighing, if one of the following
settings is selected Setup: Application 1:
Differential weighing: Generate print-
out:
Automatic after
backweighing
Auto after init.weigh
+ backweigh
Auto after tare-,
init- +backweigh.
Generating Printouts Manually
The individual printout is generated
when the r key is pressed while
there is a tare, initial or backweight on
the balance, or when d
is pressed to toggle applications.
You can generate the configured
printout manually after backweighing
if you press the r key while the
display page for the results is shown.
To generate the statistics printout,
press the r key
– when the display page for statistics
is shown,
– when the samples with a desired number
of backweighing operations is selected
(for example, statistics on all samples
with 2 backweighing operations).
The following printout is generated:
Backweighing Printout
(Example)
-------------------- Dotted line
16.11.1999 14:55:12 Date/time
Lot CH12345 Lot ID
Sample 14 Sample number
ID CX88 Sample ID
T1 + 23.458 g Tare weighing (with PT1 selected)
N1 + 125.572 g Initial weight
R (3)+ 103.684 g Backweight (residue as weight)
R + 82.57 % Residue in percent
D - 21.887 g Loss as a weight
D - 17.43 % Loss in percent
Fact + 1.10345 Calculation factor
D-Res - 24.15 o Calculated loss
Ratio1+ 21.11 % Ratio 1
Ratio2+ 121.11 % Ratio 2
-------------------- Dotted line
To Next Page
Loading...
Need help?
General
