29
System Settings (Setup Menu)
Operating Instructions Moisture Analyzer MA160
Printout
You can configure the settings for printing and data output here. Some of the
settings depend on the USB port configuration (see “USB Port” on page 32).
Under Printout measurement:
t Select the settings for printing out the results on the connected lab printer.
– Printout measurement: The printout can be activated and deactivated
during the measurement here.
– Interim results: If the printout is activated, you can also activate the
output of intermediate values during the measurement here.
– Interval [sec]: Enter the desired interval in seconds for the output of the
intermediate results.
Under Printout and Report Format:
t Configure all settings for the output format.
– Result only: Only the result of the moisture analysis is output.
– With GLP and method parameters: The GLP data and parameters used for
the moisture analysis are also output.
– User-defined: Activate the “User-defined” menu item.
Under User-defined:
t Select the data for output individually and confirm with l.
Signals
Signals
Touch signals
Acoustic signal
Status light
The key tones, acoustic signals, and status light can be switched on and off here.
The following settings are available for each signal:
– On: The signal is activated.
– Off: The signal is deactivated.
Display Brightness
Display brightness
Eco mode
Medium
Bright
The brightness of the display can be set here.
The following brightness levels are available:
– Bright
– Medium
– Eco mode: Energy-saving mode (factory setting): The brightness is reduced
after 2 min. of inactivity. To reactivate the normal brightness: Touch the screen
or open the heating module. During measurement and during the results
display, eco mode is deactivated.
Printout
Printout measurement
Printout and report format
User-defined
To Next Page
Loading...
