Sartorius MA160 - Identifiers; Methods

30
System Settings (Setup Menu)
Operating Instructions Moisture Analyzer MA160
Identifiers
Identifier
Device ID
Batch ID function
Sample ID function
The identifiers for the printout can be defined here.
– The Device ID identifier is entered here once. The device ID can be a maximum
of 14 characters long.
– The Batch ID and Sample ID functions can be activated here. The user must
then enter the batch and sample IDs before each measurement routine. Batch
and sample IDs cannot exceed 20 characters.
Under Device ID:
The device identifier (ID) is printed in the header of the GLP printout.
t To set the device ID, select Device ID, enter the desired device ID and confirm
with l.
Under Batch ID function:
The batch ID (L ID) is queried once at the beginning of the measurement routine.
t If you wish to print the batch ID, activate this option.
Under Sample ID function:
The sample ID (S ID) is queried once at the beginning of the measurement routine.
t If you wish to print the sample ID, activate this option.
To enter and delete numbers and text, e.g., for the sample ID, see “Entering Text
and Numbers” on page 24.
Methods
Methods
Sort order
Export
Import
You can define the sort order of the created methods in the menu and export the
created methods to or import them from an SD card.
Under Sort order:
t Select the desired sort order of the methods in the menu.
– Last used: Sort by frequency of use. The most recently used methods are
at the top.
– A-Z: Alphabetical sorting in ascending order.
– Z-A: Alphabetical sorting in descending order.
Under Export:
Export all existing methods to the SD card.
Under Import:
Import methods from the SD card. All of the methods on the analyzer are overwrit-
ten in this case.