Sartorius MA160 - Page 41

41
Moisture Analysis
Operating Instructions Moisture Analyzer MA160
y The current measurement value and progress are shown on the display during
the moisture analysis.
65.00 %M
Standard
Fully automatic
110 °C
09:41 min
67.50 %M
– If a target value is set, the measurement process is displayed as a bar diagram.
The target value is marked and tolerance limits are displayed.
67.00 %M
Standard
Fully automatic
110 °C
09:41 min
+
– If no target value is set, the measurement process is displayed as a curve
diagram.
The following information is also shown on the display:
– Information bar at the top right: measurement time expired
– Function bar below: method name, target temperature, switch-off criterion
t To cancel the moisture analysis before it is finished: Select <.
In the confirmation dialog that follows, select < again.
y When the moisture analysis is finished, the moisture content of the sample is
shown on the display.
The status light on the analyzer flashes three times and then goes out.
67.53 %M
Standard
Fully automatic
110 °C
11:18 min
Measurement completed
i
OK New
n
67.50 %M
– If a target value is set, the moisture content is displayed as a bar diagram.
– Bar is green: Result is within the tolerance limits.
– Bar is red: Result is not within the tolerance limits.
– Bar is orange: Measurement was canceled.
85.15 %M
Standard
End autom.
110 °C
11:18 min
OK New
n
Measurement completed
i
– If no target value is set, the moisture content is displayed as a curve diagram.
t Select the desired option:
– To perform another moisture analysis using this method:
Select NEW.
– To view the report and print it out if desired: Select n.
– To exit the measurement: Select OK.