Satel MICRA - Page 27

SATEL MICRA 25
1.2.0 or later). If events are to be sent in the form of two characters, enter the partition
symbol only.
Control
The module can be controlled by using SMS messages. The control commands should be
defined in consecutive tabs. The SMS message to be sent to the module may only contain
one control command. The control command can be composed of up to 24 characters.
SMS control only from list of telephone numbers for messaging – if this option is
enabled, the control function (arming/disarming, clearing alarms, bypassing/unbypassing
zones, activating/deactivating outputs) will be executed after the SMS message is sent
from a telephone number which is programmed in the "Telephone numbers for messaging
and test transmissions".
Confirm controlling with status SMS – if this option is enabled, starting the control function
will result in sending by the module of an SMS message containing information on the
module status to the telephone number from which the control message was sent (see:
"Send SMS with module status to CLIP" option).
Telephone numbers for messaging and test transmissions
Telephone number – it is possible to program 4 telephone numbers to which the module will
be able to send SMS messages and test transmissions, and from which will be also
possible to control the output and armed mode using the CLIP service. The telephone
number must be preceded by the country dialing code.
SMS retransmission – select the field (the field is selected when the "x" symbol is displayed
in it), if the SMS messages received by the module and sent from the telephone numbers
which are not in the list (e.g. information received from the operator of GSM network in
which the module is operating) are to be forwarded to the given telephone number.
CLIP-NO1 / NO2 – you can define in the field, whether and how the CLIP service effected
from the selected telephone number (T1 – T4) is to control the output. There are the
following options to choose from:
– 0: NO – CLIP service does not control the output,
– 1: ON – CLIP service will activate the output,
– 2: OFF – CLIP service will deactivate the output,
– 3: For a limited time – CLIP service will activate the output for a limited time (define the
time in the "Output cut-off time" field, "Options, zones, outputs" tab).
CLIP-arm – you can determine in this field whether and how the CLIP service effected from
the selected telephone number (T1 – T4) is to control the armed mode. There are the
following options to choose from:
– 0: NO – CLIP service does not control the armed mode,
– 1: Arm – CLIP service will arm,
– 2: Disarm – CLIP service will disarm,
– 3: Arm / Disarm – depending on the current system status, the CLIP service will arm or
disarm the system.
Confirmation – select this field, if the module is to use the CLIP service or SMS messages
to notify about arming / disarming with the use of CLIP service. To choose the form of
messaging and define the content of SMS message, go over to the "MKP-300 keypad" tab
("Messaging / reporting" table).
Note: The CLIP service and SMS message settings are to be programmed in the "MKP-300
keypad" tab, whether or not the MKP-300 keypad is registered in the MICRA system.