Satel MICRA - Page 29

SATEL MICRA 27
Event codes for module test transmission
The table makes it possible to define the Contact ID codes which will be sent to the
monitoring stations for the module test transmission (the code will also be written to the
event log).
Format – the field displays information that the code is sent in the Contact ID format.
CODE – program 3 digits of the event code in this field. You can also make use of the
code editor. To open the code editor window, click on the button available in the
"EVENT" field.
R – select this field, if the event code is to denote new restore/arming (click on the field
twice to select/deselect it).
Part. – enter in this field the partition number which will be included in the event message
sent to the monitoring station.
Z. No. – enter in this field the zone number which will be included in the event message
sent to the monitoring station.
EVENT – the field displays description of the event whose code is entered in the "CODE"
field. A button , which opens the editor of Contact ID codes, is also available in the
"EVENT" field.
Note: The test transmission will be sent as an event, if the following parameters and options
are programmed for the monitoring station:
– GPRS reporting (see section "Starting GPRS reporting") or SMS reporting (see
section "Starting SMS reporting") is activated,
– object identifier different from "0000" is programmed,
– reporting format is programmed,
– event code different from "000" is programmed.
Test transmissions to be sent to telephone numbers
The table allows you to define the form in which the test transmissions will be sent to the
telephone numbers programmed in the "GSM telephone, Monitoring stations" tab. Click
twice on the chosen field to select/deselect it (the field is selected if the "x" symbol is
displayed in it).
SMS – select this field, if the module test transmission is to be sent to the selected
telephone number in the form of SMS message.
CLIP – select this field, if the module test transmission for the selected telephone number
is to be realized with the use of CLIP service (the module will dial the programmed
number and then will be trying for 30 seconds to get through – the module telephone
number will be displayed in the telephone).
Note: Do not answer any call from the module, if the CLIP test transmission is to be
effected without incurring any costs.
CLIP settings
The table makes it possible to determine in detail how the CLIP test transmissions are to be
sent to the four telephone numbers programmed in the "GSM telephone, Monitoring stations"
tab. Click twice on the chosen field to select/deselect it (the field is selected, if "x" symbol is
displayed in it).
Acknowledgement – select this field if the module is to wait for the acknowledgement of
receipt of test transmission using the CLIP service. In order to acknowledge receiving the
CLIP test transmission, reject the call coming from the module.
Retries number – if the "Acknowledgement" field is selected, the test transmission with the
use of CLIP service can be conducted a specified number of times. Values from 1 to 15