To Next PageTo Next PageWhat to do if SATO Printer shows minor error paper end?
If your SATO printer displays a 'minor error - paper end' message, it means the printer is out of paper. To resolve this, set the paper properly.
What to do if SATO Printer shows minor error ribbon end?
If your SATO printer displays a 'minor error - ribbon end' message, it indicates that the printer is out of ribbon or the ribbon is ripped. Set the ribbon properly to resolve this.
How to fix minor sensor error on SATO Printer?
To fix a minor sensor error on your SATO printer, perform a level adjustment if the sensor level is wrong, or adjust the sensor type if the sensor type is wrong.
Why SATO CG2 does not turn on?
If your SATO printer isn't turning on, it might be due to the power connector or AC adapter not being properly connected. Ensure that these are securely connected.
Why SATO CG2 prints poor label quality?
If your SATO printer is producing poor label quality, it might be due to the media quality. Use higher quality media or SATO-certified media.
What to do if print head is disconnected in SATO CG2 Printer?
If the print head of your SATO printer is disconnected, power off the printer and ensure a proper connection.
How to fix download error on SATO CG2 Printer?
To fix a download error on your SATO printer, try downloading again. Note that there is no need to download LAN firmware to USB+RS-232C board.
What causes hardware error in SATO CG2?
A hardware error in your SATO printer could be due to several causes: FLASH ROM error, Setting information (FROM) error, Kanji data (FROM) error, Machine error, or Head error. The suggested solution is board replacement. Alternatively, if the cause is a head error, you can replace the print head or disable the head check function.
How to resolve communication error on SATO CG2?
To resolve a communication error on your SATO printer, consider these potential causes: buffer over or RFID error. For buffer over, correct the software on the host side or set the correct protocol. For RFID error, reset the paper or set the correct protocol.
How to fix program error on SATO CG2 Printer?
To fix a program error on your SATO printer caused by an incorrect program, download again.
General| Print Resolution | 203 dpi (8 dots/mm) |
|---|---|
| Print Method | Thermal transfer and direct thermal |
| Print Length | Up to 39.37 inches (1000 mm) |
| Memory | 8 MB Flash |
| Media Type | Labels, tags, tickets, and continuous media |
| Media Roll Diameter | 5" (127 mm) O.D. |
| Interfaces | USB, RS232 Serial |
| Optional Interfaces | Ethernet |
| Power Source | AC 100-240V |
| Supported Barcode Types | UPC-A/E |
| Ribbon Type | Wax, wax-resin, resin |
| Operating Temperature | 41 to 104°F (5 to 40°C) |
| Storage Temperature | 14°F to 140°F (-10°C to 60°C) |
