Section 3: Loading Paper
Page 3-4 CG2 Series Quick Guide
LOADING FAN-FOLDED PAPER (CONTINUOUS/CUTTER TYPE)
1. Pull toward you the cover open/close latches on both sides of the printer in order to unlock the top cover.
Then, open the top cover.
2. Pass the paper through the opened window at the rear of the unit.
3. While holding the paper holder slide lever, adjust the width of the paper holder (1) to match the paper size.
After pulling out the paper, pass it through the paper sensor. When using a cutter type printer, place the
leading edge of the paper on top of the platen roller.
①
①
Paper holder slide lever
①
①
Paper holder slide lever
To Next Page
Loading...
Need help?
General
