Section 6: Connecting to a Computer
CG2 Series Quick Guide Page 6-1
CONNECTING TO A COMPUTER
STANDARD INTERFACE
USB + LAN Type
1.
Turn on the printer while pressing the FEED/LINE button. Continue pressing the FEED/LINE button until
the ON LINE (POWER) lamp blinks green.
2. Each time you press the FEED/LINE button, the ON LINE (POWER) lamp indicator changes. When using
the USB connector, check that the ON LINE (POWER) lamp is alternating between green and red. When
using the LAN connector, check that the ON LINE (POWER) lamp is blinking green.
3. Press the FEED/LINE button for at least three seconds to register the connector type.
4. Check that the ON LINE/(POWER) lamp is lit green, and then turn off the printer. Turn on the printer again
to activate the connector.
r
To Next Page
Loading...
Need help?
General
