Unit 4: Printer Configuration
GL408-412e Operator’s Manual
4-75
Determines whether the print intensity commands processed by the printer will be those sent
from a host or those set by the printer’s operator panel.
• Process - factory default. Downloaded commands take precedence.
• Ignore - downloaded commands are ignored and printer settings take precedence.
Allows the user to disable the speed commands (Print, Feed, Reverse).
• Process - factory default. Acknowledges speed commands.
• Ignore - does not acknowledge speed commands.
Allows the user to disable the commands affecting the cutter assembly.
• Process - factory default. Acknowledges cutter commands.
• Ignore - does not acknowledge cutter commands.
Allows the selection of how the printer will respond to the software switch settings of <ESC>V
commands. this command enables Cut or Tear-Off mode, or disables both by selecting
Continuous mode.
• Process - factory default. Responds to the commands.
• Ignore - does not respond to the commands.
Allows the selection of how the printer will respond to various sensor commands.
• Process - factory default. Acknowledges sensor commands.
• Ignore - does not acknowledge sensor commands.
Allows the user to disable the commands that select the Format Attribute.
• Process - factory default. Acknowledges commands that select formatting attributes.
• Ignore - does not acknowledge commands that select formatting attributes.
TGL EMULATION MODE (TABLE 4-13)
MENU DESCRIPTION
Permits entry into the EMULATION Mode.
Allows the specific emulation to be selected or if the Select option is chosen, the menu to follow
will contain a list of emulation options available.
Allows the selection of the specific emulation to be selected from a list.
The allowable emulation options are: PGL for Printronics, ZGL for Zebra, TGL for TEC, IGL for
Intermec, SGPL for SATO, and DGL for Datamax.
DGL EMULATION MODE (TABLE 4-12)
MENU DESCRIPTION
To Next Page
Loading...
