SATO GL4xxe Series User Manual

Unit 4: Printer Configuration
GL408-412e Operator’s Manual
4-17
IGL EMULATION MODE
This chapter provides the programming sequences required to correlate the printer’s interpreter language with that
of Intermec interpretor language. Use the keys of the printer’s operator panel to select and enter the required
options.
Refer to the Menu Definition Tables in the following chapter to provide an explanation of each menu screen.
Figure 4-14, IGL Emulation Mode
ATTENTION: Perform the following programming sequence only if this is the
emulation type required. Instead, refer to the appropriate emulation chart.
EMULATION
Active
Yes*
EMULATION
Select
Select
IGL*
POWER
ONLINE
OFFLINE
LINE
FUNCTION
Emulation
Mode
ENTER
IGL Setup
Active
Error Reporting
Mode on Power Up
Print Language
IBM Translation
Slash Zero
EURO-Symbol
Preparsing Data
Status on <ETX>
Cutter Cmd (c)
PwrUpMod Cmd (C)
EOP Dist Cmd (D)
Intens. Cmd (d)
TOF set Cmd (F)
LRP adj. Cmd (f)
Speed Cmd (S)
Stock Cmd (T)
Vert. DPI Adjust
Reported model
Saving UDCs
Save state
Error Reporting
Display on LCD*
Mode on Power Up
Advanced 5mil*
Print Language
US ASCII*
IBM Translation
Disable*
Slash Zero
Font Based*
EURO Symbol
0x0*
Preparsing data
Disable*
Status on <ETX>
Enable*
Intens. Cmd (d)
Process*
TOF set Cmd (F)
Process*
LRP adj. Cmd (f)
Process*
Speed Cmd (S)
Process*
Stock Cmd (T)
Process*
Vert. DPI Adjust
0*
Reported model
Auto detect*
Saving UDCs
Automatic*
EOP Dist Cmd (D)
Process*
IGL Setup
Active*
PwrUpMod Cmd (C)
Process*
Cutter Cmd (c)
Process*
IGL Setup
Save state*

SATO GL4xxe Series Specifications

General

Brand	SATO
Model	GL4xxe Series
Category	Barcode Reader
Language	English