SATO GL4xxe Series - PGL Emulation Mode

Unit 4: Printer Configuration
GL408-412e Operator’s Manual
4-13
PGL EMULATION MODE
This chapter provides the programming sequences required to correlate the printer’s interpreter language with that
of Printronics interpretor language. Use the keys of the printer’s operator panel to select and enter the required
options.
Refer to the Menu Definition Tables in the following chapter to provide an explanation of each menu screen.
Figure 4-10, PGL Emulation Mode
ATTENTION: Perform the following programming sequence only if this is the
emulation type required. Instead, refer to the appropriate emulation chart.
Ignore Text
Disable*
Power on IGP/PGL
Enable*
Skip Cmd Prefix
Enable*
CR Edit
Disable*
PI Slew Range
16*
Optimized Ratio
Disable*
Var Form Type
Add Nothing*
Var Form Adjust
00.0 inches*
Host Form Length
Enable*
Select SFCC
126*
Slash 0
Disable*
Auto Uppercase
Disable*
Autowrap
Disable*
Define LF Code
LF= LF*
Define CR Code
CR= CR*
Select LPI
6*
Standard Sets
0) ASCII*
EMULATION
EMULATION
Select
Select
PGL*
POWER
ONLINE
OFFLINE
LINE
FUNCTION
Emulation
Mode
ENTER
PGL Setup
Character Group
Standard Sets
Select LP1
Define CR Code
Define LF Code
Autowrap
Auto Uppercase
Slash 0
Select SFCC
Host Form Length
Var Form Adjust
Var Form Type
Optimized Ratio
PI Slew Range
CR Edit
Skip Cmd Prefix
Ignore Text
Power on IGP/PGL
Ext Execute Copy
AI 00 Spaces
Select SO Char
Ignore Mode
Select Char
Do FF at TOF
Expanded Font
Scalable Size
Forms Handling
PGL Normal
UPC Descenders
I-2/5 Selection
C39 Compatibl.
User-Def Ratio
Lead PDF Dist
Trunc Dyn Data
Vertical Adjust
Error Report
Boundary Check
Repeat Form Opt
Preparser Cmd
Preparser Port
Storage Select
Character Group
Standard Sets*
AI 00 Spaces
Disable*
Select SO Char
14*
Ignore Mode
Disable*
Select Char
0*
Do FF at TOF
Enable*
Expanded Font
Scalable*
Scalable Size
Normal*
Forms Handling
Disable*
PGL Normal
LP+ Menu*
UPC Descenders
Always*
I-2/5 Selection
Loading Zero*
C39 Compatbl.
Disable*
User-Def Ratio
Enable*
Lead PDF Dist
0.10 inches*
Trunc Dyn Data
Disable*
Vertical Adjust
0 dots*
Error Report
On*
Boundary Check
Enable*
Repeat Form Opt
Enable*
Preparser Cmd
Status*
Preparser Port
Disable*
Storage Select
DISK= EMC*
Ext Execute Copy
Disable*