SATO GL4xxe Series - Printer Management Mode

Unit 4: Printer Configuration
GL408-412e Operator’s Manual
4-19
PRINTER MANAGEMENT MODE
This chapter provides the programming sequences required to connect and operate the printer through a sytems
network. The menu screens that will appear and will require address, is dependent on the interface type to be
used.
Refer to the Menu Definition Tables in the following chapter to provide an explanation of each menu screen.
Figure 4-16, Printer Management Mode
INTERFACES
Serial
Parallel
LAN / WLAN
Centronics
INTERFACES
POWER
ONLINE
OFFLINE
LINE
FUNCTION
Interface
Mode
ENTER
Printer Mgmt
SNC Port
Mgmt Protocol
SNC Port Number
SNC Port Timeout
Status Port Numb
Mgmt Port Number
Chosen:
Lan, WLAN, or Serial
ENTER
Baud Rate
19200*
Word Length
8*
Stop Bits
1*
Parity
None*
Ethernet
ENTER
Printer Mgmt
SNC Port
Mgmt Protocol
Select Port
Baud Rate
Word Length
Stop Bits
Parity
Modem
Modem NUM
Modem Status
Dial Method
Chosen:
Parallel, Centronic, or USB
ENTER
INTERFACES
Printer Mgmt
SNC Port
Disable*
Serial
Ethernet
Mgmt Protocol
PXML*
SNC Port Number
XXXXX*
SNC Port Timeout
100 seconds*
Status Port Numb
XXXXX*
Mgmt Port Number
XXXXX*
Disable
ENTER
Mgmt Protocol
PXML*
Status Port Numb
XXXXX*
Mgmt Port Number
XXXXX*
Serial
ENTER
Mgmt Protocol
PXML*
Select Port
Debug*
Host
Mgmt Port Number
XXXXX*
Modem
Disable*
Modem NUM
Enable*
Debug
ENTER
Deselect Serial
Host Interface
Host
ENTER
Modem Status
Enable*
Dial Method
Tone*