SATO GL4xxe Series User Manual

Unit 4: Printer Configuration
GL408-412e Operator’s Manual
4-15
DGL EMULATION MODE
This chapter provides the programming sequences required to correlate the printer’s interpreter language with that
of Datamax interpretor language. Use the keys of the printer’s operator panel to select and enter the required
options.
Refer to the Menu Definition Tables in the following chapter to provide an explanation of each menu screen.
Figure 4-12, DGL Emulation Mode
ATTENTION: Perform the following programming sequence only if this is the
emulation type required. Instead, refer to the appropriate emulation chart.
EMULATION
EMULATION
Select
Select
DGL*
POWER
ONLINE
OFFLINE
LINE
FUNCTION
Emulation
Mode
ENTER
DGL Setup
Active
Character Set
Euro Character
Control Codes
FeedBack Chars
Default Module
Units of Measure
Row Offset
Column Offset
Format Attrib.
Error Handling
Vert. DPI Adjust
Compatibility
Length Cmd (STXc)
Heat Cmd (H)
Speed Cmd (P,S)
Cut Cmd (o,:,c)
Soft. Switch (V)
Sensor Cmd (e,r)
Format Attr. (A)
Active
Yes*
Character Set
PC-8 CP 437*
Euro Character
128*
Control Codes
Standard*
FeedBack Chars
Disable*
Default Module
RAM*
Units of Measure
Imperial*
Row Offset
00.00 Inch*
Column Offset
00.00 Inch*
Format Attrib.
XOR*
Error Handling
Off*
Vert. DPI Adjust
0*
Compatibility
Standard*
Length Cmd (STXc)
Process*
Heat Cmd (H)
Process*
Speed Cmd (P,S)
Process*
Cut Cmd (o,:,c)
Process*
Soft. Switch (V)
Process*
Sensor Cmd (e,r)
Process*
Format Attr. (A)
Process*

SATO GL4xxe Series Specifications

General

Brand	SATO
Model	GL4xxe Series
Category	Barcode Reader
Language	English