Unit 5: Troubleshooting
GL408-412e Operator’s Manual
5-3
Printer contains an 32MB EFC and the firmware
attempted to access beyond its limit.
Contact an authorized service representative.
Printer contains an 64MB EFC and the firmware
attempted to access beyond its limit.
Contact an authorized service representative.
An attempt was made to download to a full EFC. Delete and optimize files.
An attempt was made to download to a non-
existant EFC.
Insert cartridge and repeat the process.
The printer encountered an error trying to
program flash memory.
Power off the printer for 15 seconds, then power
on again. If the problem persists, contact an
authorized customer service representative.
A Flash Write failed to complete. Try downloading again or contact an authorized
customer service representative.
A Flash Write failed to complete. Try downloading again or contact an authorized
customer service representative.
A Flash Write failed to complete. Try downloading again or contact an authorized
customer service representative.
ERROR SIGNALS
DISPLAY EXPLANATION SOLUTION
To Next Page
Loading...
