SATO GY412 - Page 118

Section 3: Operation and Configuration
Page 3-90 GY412 Operator Manual
3.3 LCD MESSAGE DETAILS (cont’d)
Display Test Print Mode - Adjustment of offset position
Onscreen
message
Adjusting offset position.
Use ↑ and ↓ keys to change setting value and
press ENTER to start test print.
The setting value can be adjusted by ±0.25mm
regardless of print density.
The setting range is ±3.75mm and the default set-
ting is “+0.00”mm.
Operation
button
Button Description
↓, ↑ Enters setting value by ±0.25mm.
←, → Toggles the screens.
ENTER Starts test print.
CANCEL Goes to the [TEST PRINT SIZE] screen.
FUNCTION Goes to the [MAINTENANCE MODE] screen.
Display Test Print Mode - Darkness setting
Onscreen
message
Adjusting print darkness.
Use ↑ and ↓ keys to change setting value and
press ENTER to start test print.
The setting value can be adjusted by 1 regardless
of print density.
The setting range is from 00 to 90.
The default setting is “50”.
Operation
button
Button Description
↓, ↑ Enters setting value by ±1.
←, → Toggles the screens.
ENTER Starts test print.
CANCEL Goes to the [TEST PRINT SIZE] screen.
FUNCTION Goes to the [MAINTENANCE MODE] screen.
OFFSET POSITION
+0.00
ENTER -> PRINT
mm
ENTER -> PRINT
50
DARKNESS